Da-lite Multi Format Imager Manual do Utilizador

INSTRUCTION BOOK FOR Multi Format Imager

10Wall Mounting Assembly:1. Depending on size of screen it will be shipped with either 2 wall brackets that are 48" long or 2 wall brackets tha

116. Wall hanging brackets must be evenly spaced across top of frame. Measure the frame width and divide by three then make two marks from the end. T

12Multi Format Imager Installation7. Hang the frame assembly on the hanger brackets as shown in Figure 22. Be careful as bracket is to slide in front

132. Install electrical connections. Make sure to review the wiring diagram for proper hook up as shown in Figure 26. NOTE: Must be installed in acc

14The Multi-Format imager has been preset to four diferent formats. The screen can be set to any format by simply pressing the corresponding button

15Multi Format Imager Intermediate Stop AdjustmentMulti Format Imager Limit Travel Adjustment1. To adjust intermediate stopping positions make sure b

16Multi Format Imager Limit Travel Adjustment6. Locate the two tactile buttons on the back of the switch. They are square silver with black round bu

17Visit www.da-lite.com to ind installation and troubleshooting videos and tutorials. You will also ind a link to Live Chat for interactive support

18

19

2Preparation: Have ample space for this available on a lat clean surface such as a large table or loor. The work area should be larger than the fram

LIMITED ONE YEAR WARRANTY ON DALITE PRESENTATION PRODUCTSMilestone AV Technologies LLC warrants certain Da-Lite branded products to the original purc

3Frame Assembly: 1. In the hardware package, you will receive (12) #10 x .375" long button head screws and (8) #10 x .500" long button head

4Tighten Set Screws Until Front Surfaces Are FlushFasten Screws Through Top Frame Assembly Into Connecting BracketSmall L BracketAluminum Guide Channe

5Tighten Set Screws Until Front Surfaces Are FlushFasten Screws Through Bottom Frame Assembly Into Connecting Bracket7. Finish assembling corner asse

69. Assemble top right and bottom right corner assembly by inserting (3) #10 x .375" long button head screws through bottom of frame into the co

711. Untape black steel wire tension cable from bottom left side assembly. Un-wire tie the cable assembly. Run black steel wire tension cable down ar

812. Assemble pinch guard bracket using (2) #10 x .375" long button head screws to opposite side of pulley bracket as shown in Figure 15. Repeat

914. Assemble pinch guard bracket using (2) #10 X .375" long button head screws to opposite side of pulley bracket as shown in Figure 17. Repeat